Design and Construction Specifications are a resource for engineers, builders, and developers to utilize in the design and construction of projects within the Soquel Creek Water District Service Area.
For construction or Engineering questions contact the Engineering Department at (831) 475-8500 or send an email
Soquel Creek Water District Standard Specifications
- Table of Contents (.pdf)
Soquel Creek Water District Standard Specifications
- Standard Specifications
Standard Plans (.pdfs)
- S-3 Standard Service Connection
- S-4 Service Reconnection
- S-5 6-Foot Chain Link Fence
- S-6 Buried Valve Assembly
- S-7 Thrust Block Details
- S-8 Meter Box Locations
- S-9 Fire Hydrant Assembly
- S-10 Fire Hydrant Placement and Clearances (Page 1/2 )
- S-10 Fire Hydrant Placement and Clearances (Page 2/2)
- S-11 1-Inch Air and Vacuum Release Valve
- S-12 Blow-Off Assembly
- S-13 Casing Installation
- S-14 Longitudinal Trench Sand Backfill
- S-15 Trench Backfill Lateral (Cross) Trenches Sand/Cement Slurry
- S-16 3-Inch and Larger Fire Service or Back Flow Prevention Assembly (Page 1/2)
- S-16 3-Inch and Larger Fire Service or Back Flow Prevention Assembly (Page 2/2)
- S-17 2-Inch Fire Service Installation
- S-18 2-Inch and Larger Service with By-Pass
-
S-19 ¾-Inch to 2-Inch Reduced Pressure Principle Backflow Prevention Assembly Installation
- S-20 2-Inch Fire and Domestic Combined Service Installation
- S-21 Reduced Pressure Principle Backflow Prevention Assembly: ¾-Inch to 2-Inch Parallel Installation
- S-22 Criteria for the Separation of Water Mains and Sanitary Sewers 1/3: Parallel Construction (Obsolete)
- S-22 Criteria for the Separation of Water Mains and Sanitary Sewers 2/3: Crossings (Obsolete)
- S-22 Criteria for the Separation of Water Mains and Sanitary Sewers 3/3: Materials (Obsolete)
- S-23 Chlorination Tap
- S-24 Construction Project Sign
- S-25 Service Manifold
- S-26 Sampling Station
- S-27 1-inch Fire and Domestic Combined Service Installation (OBSOLETE)
Standard Specifications
- Division One-General Conditions
- Division Two-General Technical Requirements
- Division Three-Materials and Construction
- Division Four-Design Criteria
- Appendix A-Cross Connection Policy